Currently Being ModeratedAug 8, 2011 2:50 PM (in response to LK Mike)
Wont disabling all services do the job?
Currently Being ModeratedAug 8, 2011 5:43 PM (in response to LK Mike)
Delete the Server folder in your Applications folder.
Currently Being ModeratedAug 9, 2011 2:23 AM (in response to LK Mike)
I don't believe that either of these suggestions will work. The server version has alterations to DNS as well as (apparently) to the way network routing works. As a case in point, domain-specific DNS resolution for IPsec with IPsecuritas works fine in Lion, but doesn't work at all in Lion Server. The tunnel interface is present, but traffic does not appear to flow down it. Hrm...could be a firewall issue, now that I think of it.
Currently Being ModeratedAug 9, 2011 2:29 AM (in response to LK Mike)
There is a technote about this on the Apple website: http://support.apple.com/kb/HT4827 but it does not become a workstation though. I have the Mini Server 2011 and if it were not for some software that refuse to install because I have a server, I would not make any difference.
Currently Being ModeratedAug 9, 2011 2:49 AM (in response to jbjoret)
Ach! I wish I'd seen your response 20 minutes ago. I'm currently restoring a machine from backup to take it to its pre-server state. Thank Jobs for Time Machine!
Currently Being ModeratedAug 9, 2011 4:52 PM (in response to LK Mike)
Please see my response to a very similar question here: https://discussions.apple.com/message/15891466#15891466
Currently Being ModeratedMay 25, 2012 6:04 AM (in response to Chris BeHanna)
You were right for the firewall Issue. I was also running IPSecuritas and I installed Lion Server and the traffic stopped responding on the tunnel, although it connected well.
I figured out that, for some reason, even if the ServerAdmin indicated that the server firewall (my local "new" server, my own machine) was inactive, some rules must had been set during Server.app installation.
Anyway, what I did was activate the firewall, and then, allow all traffic on every ip. You can do that in the ServerAdmin app.
And then the traffic turned back on, on the IPSecuritas tunnels.
The next step would be to be configure rules precisely, but since I am already behind a firewall, I prefer using a "transparent" setting.