Currently Being ModeratedOct 18, 2012 5:12 AM (in response to Jailer Joe)
Currently Being ModeratedOct 18, 2012 3:51 PM (in response to sig)
Thanks but that didn't help. The MP Navigator won't even launch (it gives a"the scanner driver supported by this software is not installed. Install it and then retry." error message) and I really don't want to have to scan through anything other than Image Capture anyway. The Canon page for Mountain Lion support states that my printer is fully supported and since there isn't any downloadable drivers or updates for my printer I can only assume that the drivers are included with Mountain Lion and something is preventing them from loading.
Any other ideas?
Currently Being ModeratedOct 18, 2012 6:47 PM (in response to Jailer Joe)
According to this Apple KB article, there is no ICA driver available from Apple for the MP600 and MP600R. The ICA driver is needed to scan with Image Capture. Checking the Canon Australia web site, they also do not have the ICA driver for this model. And, looking through the two Canon IJScanner plugins, located in HD > Library >Image Capture > Devices, the MP600 is not listed as a supported device. So I don't see how you would have used Image Capture on 10.8 with the MP600.
As for MP Navigator, the link shown above was for a CanoScan 5600F, which uses a different version of MP Navigator and scanner driver. So to use the MP600 with MP Navigator, you would need to get the correct version for MP600. But with reference from the Canon Australia web site, there is only 10.7 supported versions of Navigator and scanner driver. So unless another Canon site has a later version, you may not be able to scan from the MP600 on Mtn Lion.
Currently Being ModeratedNov 6, 2012 4:58 PM (in response to Jailer Joe)
The problem is that Apple says the scanner is no longer supported:
But Canon says that it is:
My scanner used to work under all previous versions of OS X, but no luck in OS 10.8.
Currently Being ModeratedNov 21, 2012 11:33 AM (in response to Jailer Joe)
It looks like the latest Canon printer software (version 2.11) released by Apple on 11/6/2012 fixes this. After installing, I deleted my MP600 and added it back in. Now the scanner works again. Yippee!
Currently Being ModeratedJan 16, 2013 12:36 PM (in response to Jailer Joe)
After a lot of searching on the internet I found this:
Although it states that it's only compatible with 10.7 thought I'd give it a go and now image capture works with my mp600 scanner.
Not sure how but it does.
Currently Being ModeratedJan 17, 2013 12:50 PM (in response to legendarybc)
This might have been my fix, too. I did as this instructed; however, after installing v.2.11 from Apple's site and deleting the printer, then adding it back again (I also unplugged and replugged the printer), nothing changed.
I then did as "noseyp" below suggested and at the Canon site added the scanner driver for Mac OS 10.7. That process (after I bypassed my security roadblock), required a computer restart.
So was is it v.2.11 installation (plus the restart) that made the difference? Or was it the 10.7 scanner driver? I won't know.
I'd suggest to anyone to do as "legendarybc" suggested, but then do restart your computer. If that doesn't work, then add the 10.7 scanner driver from:
Currently Being ModeratedJan 20, 2013 11:11 AM (in response to Darran Hanson)
That did the trick for me as well. I updated to latest version of Lion and then downloaded and installed the driver as you suggested. Thanks! My MP600 is back in action. At least until OS X breaks it again.