Currently Being ModeratedNov 18, 2012 1:50 AM (in response to quasarousal)
And oh, there's Clicks and Pops when I go below 128...
Currently Being ModeratedNov 18, 2012 6:57 PM (in response to quasarousal)
You direct monitor the mic input out of the duet BEFORE it goes into logic. Turn software monitoring off, open the maestro control panel and ,in the mixer window, turn up the input monitoring of the channel you have the mic plugged into.
Currently Being ModeratedNov 18, 2012 11:31 PM (in response to quasarousal)
Also, Low Latency mode does nothing unless you're using certain plugins that cause latency, otherwise it has zero effect, I'd disable it if not needed.
Currently Being ModeratedNov 21, 2012 1:42 PM (in response to Data Stream Studio)
Got that.. Thx.
But... How do I feed any of Logic's channel strip settings into my headphones while direct-monitoring off the Maestro Mixer ?
Trust me, it really helps to bring out a great performance from a singer if they hear the vocals that are being tracked with a few effects like reverb n' echo in their headphones WHILE they sing/track the vocals.
But what we want recorded is a dry signal, without any of the effects the singer is hearing on his/her headphones while they sing.
Now when I was working exclusively on Garageband, I could do this pretty easy. There weren't any latency issues too till my hard-drive bloated and OSX got sluggish.
Since a clean install and the move to Logic, it's been a mess really. I can't seem to get my way round this yet.
I always have Maestro open btw... In the mixer, the 'From Software' and 'To Hardware' faders are set to 0dB each. And Input 1, where my mic goes, is at 0dB too.
Where do we go now ?