Skip navigation

Dual G5 with erroneous date at start up _new Pram battery , any idea?

597 Views 9 Replies Latest reply: Dec 19, 2012 6:50 AM by Boscobrains RSS
Jean-Baptiste Bocle Calculating status...
Currently Being Moderated
Dec 11, 2012 4:08 PM
This a G5 2.5 DP mid 2004 , identified as M9457LL/A or PowerMac 7,3.

This is a G5 Dual 2.5 ghz mid 2004 (M9457LL/A , PowerMac 7,3)

running  OS 10.4.11 with  7 Gig RAM , I get this message at start up , 9 times

out of 10:

" your computer's clock is set to a date before march 24th 2001 this may

cause some applications to behave erratically."

then the fans go full blast for a while . once in a while it won't start up at all,

just gray screen , then if I leave it off the power strip for a while , it'll start up  again

with the same behavior.

I have replaced the PRAM battery , reset said Pram , reset PSU ...tested RAM..

with no results,

any ideas if this is a hardware issue?

besides the date issue at start up and the fans acting up it still runs well and is a good addition

to my Mac pro to recall old projects and use some plug ins , but I'm afraid this might

be symptomatic of something failing somewhere , any suggestions would be great.

Thanks.

 

JB

Power Mac G5 (June 2004), Mac OS X (10.4.11)
  • Jacumba Level 4 Level 4 (2,325 points)

    If the computer clock reverts back in time that should indicate a pram battery. Or that could happen with a good pram battery, if the firmware/bios were updated in a old computer, which then might be not able to be reversed. And should have never been updated anyway unless the computer was new and a update was needed then.

     

    It's unlikely that a 2004 G4, or most computer's from that era, would support 7 Ghz of ram.

     

    You could take a look at the fans for a severe dust build up, but maybe a hardware failure. Or try putting the original ram back in the computer. If the ram was changed, and it has with this G4, then the firmware memory may not be reading hardware at startup.

  • Jacumba Level 4 Level 4 (2,325 points)

    Sorry you are correct I would have never suspected a computer of that era would take 8 Ghz of ram so didn't even bother to consider it.

     

    http://support.apple.com/kb/HT2248

  • Brewster Magneto Level 1 Level 1 (40 points)

    Jean-Baptiste, have you tried starting your system in Safe mode? This disables all startup items and loading of non-esssential kernel extensions. (Wondering if you have a corrupt kernel extension that's messing up the boot process.) For Safe mode: (1) Shut down then power up the computer (don't reboot), (2) after the startup tone, hold down Shift key, then (3) release Shift when the gray Apple logo and spinning wheel appear.

  • Jacumba Level 4 Level 4 (2,325 points)

    I'm not sure what to make of it either exactly but will offer some suggestions.

     

    Where the computer is starting but getting only a black screen I first thought pulling the ram. That it may be corrupted, the wrong ram, or a bad slot. Pulling the ram in that situation has and does work, in your case it didn't.

     

    When a cpu fan doesn't run at all, it's a clear indication the fan itself, or power supply. But fans running to fast can also indicate a bad fan.

     

    I don't believe it's a power supply, bad fan, hard drive, or battery. I seem to think a aging G5 computer having logic board failure? There appears to be alot of these same post with the same issues with these old G5's.

  • Jacumba Level 4 Level 4 (2,325 points)

    Also don't give up on this computer too soon. Try using the cuda button and using the ram in different slots without not having all of them in place with start ups.

  • Boscobrains Level 1 Level 1 (30 points)

    Also remember to keep the RAM in matched pairs. I seem to recall that the G5s were really picky on this matter.

Actions

More Like This

  • Retrieving data ...

Bookmarked By (0)

Legend

  • This solved my question - 10 points
  • This helped me - 5 points
This site contains user submitted content, comments and opinions and is for informational purposes only. Apple disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Apple Support Communities Terms of Use.