Currently Being ModeratedDec 28, 2012 10:22 AM (in response to Angel Llorente)
Whew, been a long time since I've seen that message, don't quite remember, but do you have any external drives, Flash Drives, camera cards, etc. attached?
Might try this...
"Try Disk Utility
1. Insert the Mac OS X Install disc, then restart the computer while holding the C key.
2. When your computer finishes starting up from the disc, choose Disk Utility from the Installer menu at top of the screen. (In Mac OS X 10.4 or later, you must select your language first.)
*Important: Do not click Continue in the first screen of the Installer. If you do, you must restart from the disc again to access Disk Utility.*
3. Click the First Aid tab.
4. Select your Mac OS X volume.
5. Click Repair Disk, (not Repair Permissions). Disk Utility checks and repairs the disk."
Then try a Safe Boot, (holding Shift key down at bootup), run Disk Utility in Applications>Utilities, then highlight your drive, click on Repair Permissions, reboot when it completes.
(Safe boot may stay on the gray radian for a long time, let it go, it's trying to repair the Hard Drive.)
Yes, I do have two (2) external drives, plus an iomega Zip 250 Drive.
I tried Disk Utility from my Mac OS X Install disc, and I also tried the Safe Boot directions, but to now avail.
As a matter of fact, as I was repairing the main hard disk (the one that's partitioned with 9.2.2); I got the following warning for many of my SUID files:
"Waring: SUID file xxxx has been modified and will not be repaired." What does that mean?
Before I installed new software and hardware during December 2012; I didn't have the "problem" listed above. I had two external drives connected and everything worked well.
Before the installation of new software and hardware, I disconnected everything from my G4 tower. This happened during December 2012. Then I installed new hardware and new software in this sequence:
1. I installed an all-in-one device and then it's software.
2. I then connected the two external drives, but I didn't re-install their software as it was already on the disk.
3. I then installed the iomega Zip 250 drive and it's software.
It wasn't until after I installed the all-in-on and software; and Zip 250 drive and software that I began to have the "problem" listed above.
Since installing the all-in-one I haven't used it yet. On December 27, 2012 I ran a hard drive test with DiskWarrior and got the following:
File: "com.epson.Inkjet Printer Driver. UnInstallList.plist"
Detected that "Propert List" data is "damaged" and cannot be repaired.
XML parser error:
Unexpected character P at line 1
Old-style plish parser error:
Unexpected ";" or "=" after key at line 2
Location: "Hard Disk/Library/Preferences/"
I got the same alert for the printer, scanner, and fax (all-in-one).
What does this all mean?