Skip navigation

My iBook G4 struggles to turn on, why?

522 Views 3 Replies Latest reply: Feb 9, 2013 6:16 PM by ipod and ibook RSS
PlayingHisFlute Calculating status...
Currently Being Moderated
Jan 29, 2013 7:22 AM

I recently got this thing. It started at OS X 10.5.1 and I updated it to OS X 10.5.8 almost immediately. It was running like a dream last night (I have had it less than 24 hours) and then I shut it down for the night and left it to charge. This morning when I tried to turn it on, pressing the power normally did nothing. I held down the power and it made this loud BEEEEP and then the ready light flashed a few times. Still nothing. I repeated doing this about 4 times before it got to where it is now, up and running. Is there a reason for this? Is it the updated system? I barely put ANYTHING on the hard-drive memory wise, I just have a few pictures on here as of now and some small video files, not even full movies. That's it. Is it defective? Should I be contacting the seller over this? Or is it something I've done to it?

iMac, iOS 5.0.1
  • dalstott Level 4 Level 4 (2,445 points)
    Currently Being Moderated
    Jan 30, 2013 12:25 PM (in response to PlayingHisFlute)

    How many times does it beep? There is likely a RAM problem.

     

    The power on self-test resides in the ROM of the computer. This test runs whenever the computer is turned on after being fully shut down (the power-on self-test does not run if the computer is only restarted).

     

    If a fault is detected during the test, you will not hear a normal startup chime. Instead, the system will beep as explained below. If you experience one of these beeps, you may call your Apple Authorized Service Provider for additional troubleshooting assistance.

     

    1 beep = no RAM installed

    2 beeps = incompatible RAM types

    3 beeps = no good banks

    4 beeps = no good boot images in the boot ROM (and/or bad sys config block)

    5 beeps = processor is not usable

     

    In addition to the beeps, on some computers the power LED will flash a corresponding number of times plus one. The LED will repeat the sequence after approximately a 5-second pause. The tones are only played once.

  • Knucklesmac Level 4 Level 4 (2,225 points)
    Currently Being Moderated
    Feb 1, 2013 12:48 AM (in response to PlayingHisFlute)

    Hello,

     

    There could be any number of reasons why your iBook done that. It could be something a simple as a loose or faulty memory module installed under your keyboard. What I suggest you try doing is resetting the PMU should this happen again. If you continue to experience this problem, then I would run he Apple hardware test just to get some diagnostics on this fault.

     

    Best of luck

  • ipod and ibook Level 1 Level 1 (0 points)
    Currently Being Moderated
    Feb 9, 2013 6:16 PM (in response to PlayingHisFlute)

    try takeing out the battery and putting it back in and all ibooks will beep if you hold the power button too long i hope i helped

Actions

More Like This

  • Retrieving data ...

Bookmarked By (0)

Legend

  • This solved my question - 10 points
  • This helped me - 5 points
This site contains user submitted content, comments and opinions and is for informational purposes only. Apple disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Apple Support Communities Terms of Use.