Skip navigation

TS2570: Mac OS X: Gray screen appears during startup

Learn about Mac OS X: Gray screen appears during startup

TS2570 Grey scene on start up. Error message on disc utility?

495 Views 3 Replies Latest reply: Feb 11, 2013 5:02 PM by BGreg RSS
leslie197 Calculating status...
Currently Being Moderated
Feb 11, 2013 12:54 PM

I had a number of kernel panics a few days ago.  Now have grey screen at startup for about 20 minutes. Did everything apple suggested and now am stuck at disc utility.  It only allows me to verify disk permissions for the OS installation disc.  When I do, I get error message: the underlying task reported failure on exit.  Any suggestions?  I can't even use apple support as the computer was manufactured over 5 years ago even though I have only had it for 4.  I don't live anywhere near an apple store.

iMac (20-inch Early 2009), Mac OS X (10.5.8), Grey screen start up issues
  • BGreg Level 6 Level 6 (17,500 points)

    If you're getting a failure on exit message, that sounds like you were either able to run a verify disk, or more likely were able to boot from your original OS X DVD, bring up Disk Utility, and run a repair disk. If Disk Utility can't fix a disk error, it usually gives a message and then says "failure on exit".

     

    One of two situations exist ... either there is a data issue with the structures on the hard drive, which can usually be fixed by Disk Warrior or TechTool Pro, with Disk Warrior being the more popular solution. However, Disk Warrior can't repair an issue that is caused by a hardware problem. In that case, you can try zeroing the hard drive by writing zero's to the surface and restoring from a backup, or you can just get a new hard drive. Writing zero's to the hard drive may be a temporary, not long term, solution.

     

    Have you tried to run the Apple Hardware Test? Run the extended test when prompted, and the test can take over an hour to run.

  • BGreg Level 6 Level 6 (17,500 points)

    I would use Disk Utility to do a secure erase by writing zero's to the hard drive, then do your installation, followed by any restore needed from backup. If that completes, download SMART Utility and see what it says about the health of your hard drive.

     

    Or you can spend $99 and buy Disk Warrior, too.

Actions

More Like This

  • Retrieving data ...

Bookmarked By (0)

Legend

  • This solved my question - 10 points
  • This helped me - 5 points
This site contains user submitted content, comments and opinions and is for informational purposes only. Apple disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Apple Support Communities Terms of Use.