TS1589: Wi-Fi base station: Understanding and resolving a blinking amber status lightLearn about Wi-Fi base station: Understanding and resolving a blinking amber status light
Currently Being ModeratedApr 7, 2012 7:52 PM (in response to Sureshreddys)
A persistent, flashing amber light indicates that any of the several potential conditions may require your attention:
- The base station has not yet been configured because it is new, or the reset switch has been set.
- You have selected a security configuration that is not recommended.
- One of several other conditions, such as a disconnected Ethernet cable or invalid IP address has been detected.
If you run the AirPort Utility, it will show an amber circle on the summary page next to the area(s) causing the problem. Click on this amber circle and it should provide an explanation.
Currently Being ModeratedAug 4, 2012 2:11 PM (in response to Sureshreddys)
the amber blinkiinng light indicates a couple things
1> Firmware update
2> Not fully configured
3> Network wiht out password
4> Not a vaild IP
5> No dns servers
6> double nat
7> ethernet cable unplugged
Best thing to do would be to open Airport utility And see what the status says.
If its just a back up then you mostly likely you didnt connect ethenet canles and its going to be 3 errors. > error 4/5 and 7 fromt eh list above >> just ignore all the errors
Currently Being ModeratedJun 12, 2013 11:07 PM (in response to Sureshreddys)
Tesserax was helpeful -- I had a blinking amber light on my Apple Time Capsule; had forgot that I had changed my Apple ID Password. I went straight to the Airport Utility and re-entered my new Password; Fixed! Sometimes it's the little things that seem like more profound problems! Thank you Tesserax -- I like Iron Man too!
Currently Being ModeratedJul 25, 2013 11:30 AM (in response to jamestrenda)
turns out it was actually a problem with a drive connected to time capsule. i noticed this because as soon as i unplugged that drive from time capsule, the light turned green. so i connected that disk directly to my computer and ran disk utility, which revealed a problem with the partition map and "loader space"...whatever that means. I tried to repair it, but it failed the first time as it has 3 partitions. i had to verify each one, which I did so successfully. once each one was verified, i was able to go and repair the whole disk, even though I believe only one of the partitions, the Time Machine partition, was the culprit.