Currently Being ModeratedAug 15, 2013 8:39 AM (in response to dinky2)
Currently Being ModeratedAug 15, 2013 8:44 AM (in response to dinky2)
See this User Tip for an explanation of the "Primary Only" flag, that Frank Caggiano mentions - the thicker border you are describing is marking the "Primary Selection":
Currently Being ModeratedAug 15, 2013 1:26 PM (in response to dinky2)
Thank you guys, for answering this. Unfortunately your suggestion does not apply in my case, because I do not have "Primary Only" selected. Moreover, when I e.g. apply keywords to a selected set of images they are applied to all of them, so that works as it should. So far only GPS data does not behave correctly. Fortunately it is possible to use Lift & Stamp, but it should not be necessary.
I have filed a bug report
Currently Being ModeratedAug 15, 2013 1:47 PM (in response to dinky2)
Rereading your post, I think the problem is, that you are assigning the location from the Info panel and not from the Metadata menu. The Info panel and the Metadata menu ar behaving differently.
The Info panel will always only affect the primary selection, but the Metadata menu will work on all selected images (unless "Primary only" is checked). So , if you want to assign your location to multiple images, use "Metadata > Assign location" instead of the little map in the "Info" panel.
Or use the "Places" view. Then you can drag all images at once to the same pin on the map.
Currently Being ModeratedAug 15, 2013 2:04 PM (in response to léonie)
Thanks a lot, LeonieDF. This is exactly what I was looking for.