2 Replies Latest reply: Oct 19, 2013 9:57 PM by kaz-k
Jgoaks Level 1 Level 1 (0 points)

Hi,

Hopefully someone can help me. I just acquired a powermac G4 MDD with a 22" cinema display. It's running OS9 and OS X Tiger. It has been running fine until recently when I turned it on and the power button just blinks at me. It's running but the monitor will not turn on. If I unplugg the monitor from the computer the light stops blinking. Any suggestions? Please help.


PowerMac
  • 1. Re: Powermac g4 mdd
    BDAqua Level 10 Level 10 (116,475 points)

    Hello,

     

    Can you count the beeps or flashes?

     

    1 beep = no RAM installed

    2 beeps = incompatible RAM types

    3 beeps = no good banks

    4 beeps = no good boot images in the boot ROM (and/or bad sys config block)

    5 beeps = processor is not usable

     

    In addition to the beeps, on some computers the power LED will flash a corresponding number of times plus one. The LED will repeat the sequence after approximately a 5-second pause. The tones are only played once.

     

    Note: In this case, a flash is considered to be 1/4 second or 250 ms or greater in length.

     

    http://support.apple.com/kb/HT1547

     

    Apple LCD displays: Power light flashes...

     

    http://support.apple.com/kb/HT2811?viewlocale=en_US

  • 2. Re: Powermac g4 mdd
    kaz-k Level 4 Level 4 (2,445 points)

    Power supply is a little bit weak, especially 25V output?