Skip navigation

Restore Time Machine backup to Raid 0 (Striped set)?

952 Views 4 Replies Latest reply: Nov 22, 2013 5:21 AM by John Lockwood RSS
entreprenerd Level 1 Level 1 (0 points)
Currently Being Moderated
Nov 21, 2013 5:26 AM

I've been struggling with setting up my Mac mini (late 2012) server with a Striped RAID set and then restoring a Time Machine backup to the new RAID 0 volume. Here are the steps I have undertaken:

 

  1. Bought a 3TB Airport Time Capsule and created a full restore of my existing Time Machine backups to it.
  2. My Mac mini has dual 1TB hard drives. Pressed Command + R on bootup and entered recovery mode.
  3. Using Disk Utility, I created a Striped RAID set by adding both my 1TB drives as slices to a new RAID set and clicked on Create.
  4. After the RAID set was created, I exited Disk Utility.
  5. Clicked on Restore from Time Machine Backup.
  6. The process fails as it cannot create a Recovery Partition on a RAID set.

 

After much exploration, I think the problem can be resolved by attempting to Reinstall OS X on Step 5 and then attempting a Time Machine restore after the core OS is in place. Thoughts?

Mac mini, OS X Mavericks (10.9)
  • lllaass Level 10 Level 10 (135,430 points)

    Additional Information

    A Recovery partition cannot be created on RAID volumes. If your startup device is a RAID volume, you back up and reconfigure your computer to use a non-RAID boot volume. If needed, create a separate RAID volume for data which is not the target of the OS X installation. You can also create an external, bootable drive with a Recovery partition, as described above.

    See this article if the following message appears during the install process:

    • "Install Failed: OS X could not be installed on your computer. OS X can't be installed on the disk because a recovery system can't be created. Visit www.apple.com/support/no-recovery to learn more"

     

    From:

    http://support.apple.com/kb/HT4649

  • Linc Davis Level 10 Level 10 (107,980 points)

    After installing the OS and booting from it, you'll be prompted to transfer data from a backup, among other options. Do that.

  • John Lockwood Level 5 Level 5 (5,075 points)

    For this sort of situation of wanting to make a server RAID1 I normally clone everything off the server to an external drive, setup the RAID1, then clone everything back. CarbonCopyClone is perfect for this.

     

    You will also need an external boot drive.

Actions

More Like This

  • Retrieving data ...

Bookmarked By (0)

Legend

  • This solved my question - 10 points
  • This helped me - 5 points
This site contains user submitted content, comments and opinions and is for informational purposes only. Apple disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Apple Support Communities Terms of Use.