HT204350: Move your content to a new Mac

Learn about Move your content to a new Mac
bwgunia
Level 1 (4 points)
Mac OS X

Q: migration assistant mavericks.

I am trying to migrate to a new imac using migration assistant. I connected the old machine and new via ethernet cable. When the files began to transfer, the indicator reported over 400 hours to transfer. Suspecting the files were transferring via WiFi rather than ethernet cable, after over an hour with litte change in the counter, I disconnected the WiFi source and, sure enough, the machines stopped communicating. I also noted that Migration Assistant was telling me that connecting an ethernet cable would speed things up but the cable was already connected.

  I stopped the transfer, switched off the airport and tried again, following to the letter Apple's Mavericks Migration Assistant instructions. I have been watching both machines search for each other for going on half an hour now and cannot understand why these machines are not seeing each other. Both are running Mavericks.

MacBook, Mac OS X (10.5.8)

Posted on Jan 14, 2014 7:03 AM

Close
bwgunia

Q: migration assistant mavericks.

  • All replies
  • Helpful answers

  • by Eric Root,Helpful

    Eric Root Eric Root Jan 14, 2014 10:55 AM in response to bwgunia
    Level 9 (71,941 points)
    iTunes
    Jan 14, 2014 10:55 AM in response to bwgunia

    Do you have another Ethernet cable you can try? You can also use FireWire or ThunderBolt.

     

    You might want to update your profile. It is showing 10.5.8.

  • by bwgunia,

    bwgunia bwgunia Jan 14, 2014 9:59 PM in response to Eric Root
    Level 1 (4 points)
    Mac OS X
    Jan 14, 2014 9:59 PM in response to Eric Root

    I noticed that the old imac's network preferences indicated that the ethernet port was "inactive". I bought a new cable, plugged the ethernet cable from the modem into the old imac to "reactivate" the port. Then reconnected the two machines via ethernet and ran Migration Assistant again and the migration went fine. I'm not sure which step caused the desired effect but that's what I did.