Q: iPhone 6 is not working for calls with uconnect?
I cleared all devices on the my uconnect and then I paired with my iPhone 6. I was able to play music through the bluebooth. When I make a call, I start it through the uconnect. It will search the address book, dial out, but then after the first ring, it says call completed. When in fact, the call is still active on my phone. I also tried to start a call from my iPhone and that still did not work. The uconnect did not pick up the fact that I started a call.
I know it is not an iOS 8 issue because I was able to use my iPhone 5 with iOS 8 without issues.
iPhone 6, iOS 8
Posted on Sep 22, 2014 6:15 AM
I had a similar issue. I have a 2010 Volkswagen Routan (which is a Dodge Caravan/Chrysler Town & Country) with Uconnect and had an iPhone 4S updated to iOS8 and had no issues. I got the iPhone 6 yesterday and paired with no issue. When I tried to make a call, the radio would go silent (as it should be), but you here no rining, nor call timer indicating the call. I was calling my daughter and I had to go to the speaker to hear her. I read that this is an issue that is not manufacturer specific and that a large number are experiencing this (and have mentioned that their older phones with iOS8 worked fine). Read through some solutions, and the one that I used worked for me. What I did was delete the pairing of the iPhone 6 in the car and also the iPhone 6. I did a hard reset of the iPhone 6 and waited until it rebooted. Went through the pairing procedure and tried a call. It worked!
I also been reading about dropped calls, but I have only done two calls so far using the bluetooth in the car, so I cannot comment on this.
This has to be an iPhone 6 issue since it is not iOS8 causing the problems, but the iPhone 6.
Hope this work around works for you.
Posted on Sep 22, 2014 5:15 PM