jgcaldwell

Q: FCPX 10.1.2 shape mask problems in multi cam project

Upon upgrading FCPX to 10.1.2 from 10.1.1 (by accident--autoupdate was on) then updating an existing multi-cam project, the right one-fourth to one-third of all shots containing shape masks had disappeared as if that portion of the shot had been cropped away.  When I replaced the bad shot by cutting to that same angle a few frames earlier in the timeline, the shot was fine even after I re-added a shape mask to the shot.  But as soon as I start to adjust color, saturation or exposure of the shape mask, the right one-fourth to one-third of the shot immediately disappeared.  Deleting the shape mask returns the shot to normal.  For now, it doesn't appear I can use any shape masks in this multi-cam project.

 

Good advice to never update FCPX in the middle of a project.

Posted on Jun 30, 2014 7:57 PM

Close

Q: FCPX 10.1.2 shape mask problems in multi cam project

  • All replies
  • Helpful answers