Looks like no one’s replied in a while. To start the conversation again, simply ask a new question.

possible in hyper editor?

Is it possible to use the hyper editor to do something like: attach a pitch change to the end of all the (midi) notes within a certain range or time frame? In other words, if I want each note from bar 1 to 20 to bend up 4 semitones, is that possible?

macbook pro, Choose

Posted on Aug 7, 2007 8:41 AM

Reply
3 replies

Aug 7, 2007 1:31 PM in response to Randall Thomas

to be a bit clearer: say I have recorded eight 1/8th notes within a couple bars using a synth (like sculpture or whatever you like). I want each of those notes to start at the normal pitch, then bend upward.

Now I could just hyper-draw the pitch bend, but if I am going for that same pitch-bend effect on say 100 or more notes, my mouse will wear out from all the hyper-drawing.

So is there a way to do this quickly? Maybe with the list editor?

This might sound like a dumb application, but there are other reasons for this, too. Thanks!!

Aug 7, 2007 4:27 PM in response to Jon H.

OK, then just draw one eighth note of pitch bend data, you'll need a hi-res grid for it to be meaningful, copy it, move the spl to the next note location and paste. You can do this all with key commands.

The problem is that you have little control over it, other than varying the scaling that the synth responds to pitchbend. It did however, only take me 45 seconds and a few mouse clicks to open Sculpture, target envelope 2 to Pitch and set up the envelope for an eigth note sync'd to tempo. Then you just automate/toggle the Enable Envelope 2 Target 1 parameter for the bars that want the effect.

But hey, if you want to do it with pitchbend, then you go guy!

possible in hyper editor?

Welcome to Apple Support Community
A forum where Apple customers help each other with their products. Get started with your Apple ID.