How to set default gateway

Question

How to set default gateway

I have a G5 Xserve that is on the inside of the schools network and everything works well. I want to be able to use Quicktime Streaming server to broadcast to the outside and in order to do this I have been told to set the default gateway. I have an outside and inside IP address that are different and I have been given the default gateway IP address to use but I can't find where to type in the default gateway in the Server Admin. Any comments would be appreciated.

Posted on Sep 8, 2005 8:45 AM

Reply

Answer 1

Sep 8, 2005 9:32 AM in response to Nathan Fregien

to set up a default gateway to the outside, you most go to:

Applications/Server/Gateway Setup Assistant

to set a default gateway!

DID THIS HELP

Reply

Answer 2

Sep 19, 2005 1:45 PM in response to Sean Mc Carthy

No this didn't help. I only have one ethernet connection going into my Xserve and that connection gets me to the internet and to my LAN so I can administer the Xserve remotely on my G5. When I went into Gateway Setup Assistant it wanted the WAN network interface (that is Built-in Ethenet 1 for me) and the LAN interface which is also Ethernet 1 in my case so it won't let me continue the set-up unless I choose Ethernet 2 or Firewire or serial port. Again I can stream to any computer on our network fine but no one can see the stream from the outside. I am stumped.

Reply

Answer 3

Sep 20, 2005 2:08 PM in response to Nathan Fregien

Terminal, not Server Admin.

<http://www.apple.com/server/documentation/>, Command-Line Administration document, "Viewing or Changing IP Address, Subnet Mask, or Router Address" on page 50.

Reply