EXS24 Mod wheel assignment possibility?

Question

Level 1

100 points

EXS24 Mod wheel assignment possibility?

Is there a way of assigning Velocity/Volume to the mod wheel in EXS24? I am trying to keep the Volume constant on one of my EXS24 samples but the sample I have loaded increases in Volume automatically. I want to keep it constant via the mod wheel (or change it to MY liking via the wheel). Is this possible in ESX? I can do it in K2 with no problem but can't figure out how to do it within the EXS24.
Any suggestions are appreciated. Thanks.

Power Mac Pro, 2 X 2.66 Dual Core, 2 GB Ram, Mac OS X (10.5.1), Logic Studio 8.01

Posted on Dec 20, 2007 8:50 AM

Reply

Answer 1

Dec 20, 2007 9:34 AM in response to Wolfi228

Sure it's possible by editing the Modulation matrix on the main interface of the EXS, located in the middle section. Set "Volume" as the destination (click on "Dest"->menue opens with the available destinations) and your Modwheel as a "Source" (click on Source->menue opens->choose Ctrl#1).

Reply

Answer 2

Wolfi228 Author

Level 1

100 points

Dec 20, 2007 9:47 AM in response to Sampleconstruct

I tried that, nothing is moving though. I assigned Volume to Dest. and then Source to cntrl #1. I also tried other ctrl#'s but nothing happens. There are 2 cntrl's which it says are not available (cntrl 7 and 120) hope its not one of these two.
Do I leave the middle selection called "via" blank?
Thanks

Reply

Answer 3

Dec 20, 2007 11:01 AM in response to Wolfi228

Set the slider to 100% and select the "inv" (the button turns orange) function for controller 1. Every available controller available in the menue can be assigned as a Source so it has nothing to do with the controller numbers you mentioned.

Reply