Power Support Anti Glare Film Set-How to Clean Sticky Side???

Question

RIPNHL2005 Author

Level 1

45 points

Power Support Anti Glare Film Set-How to Clean Sticky Side???

I went with the anti glare because of blocking fingerprints and smudges.

How are you supposed to clean the sticky side of it if you have dust on the back so you don't get either more dust on back or watermarks?
I inadvertently got some dust on top portion and although its not hurting anything it does annoy me and I want to clean it off.

Thanks

Patrick

Windows XP Pro

Posted on Jul 19, 2008 4:02 AM

Reply

Answer 1

Jul 19, 2008 7:24 AM in response to RIPNHL2005

Yeah, I know the instructions say you can "clean" it (aka reusable), but running water over the sticky side doesn't do anything. If you try and wipe it with something it makes it worse.

My advice, buy a new set. That's what I did

Reply

Answer 2

rtln

Level 2

193 points

Jul 19, 2008 7:55 PM in response to RIPNHL2005

I have had reasonable luck using a mild dish soap and water to clean the sticky side. Just use your fingers to gently wipe it with soap (a very small drop should do fine) and then rinse it off. Use a can of compressed air to blow it off quickly without watermarks and stick it back on. Remember to NOT shake the compressed air canister and hold it upright so you don't get the fluid coming out.

Hope it works for you.

Reply

Answer 3

RIPNHL2005 Author

Level 1

45 points

Jul 20, 2008 6:09 AM in response to rtln

Thanks rtln,

I never thought of compressed air to blow it dry to prevent watermarks, good idea!!!

Thanks

Patrick

Reply