How do I create keyswitches in EXS24?

Is it possible in EXS? If yes, try opening a file that has keyswitches (like some .gig files) and look at how it's done there.

Hope this helps.

Alex

MikeTicehurst wrote:
I'm trying to figure out how to set up keyswitches in EXS24. I've read & re-read the manual and can't figure out how to do it.

Can anyone assist?

It's been a few years since I created key switched programs for the EXS, so I'm a bit rusty... but looking over the newly designed interface of the EXS in Logic 8...

First open the EXS editor, and the assign any layers you want controlled by a key switch to a group.

Then open the groups tab (top left corner of the editor), and look for the "Select By Group" column. Here you'll assign the key switch by first defining "type" as "note", and "number" will be the actual MIDI note value (C1, C#1, etc..) Just remember to assign this to a note value outside of the instruments register.

Hope that gets you going in the right direction...