Looks like no one’s replied in a while. To start the conversation again, simply ask a new question.

connect MacBook to Performa 6400

I want to connect my Performa 6400 to my MacBook. Both have Ethernet. What's the proper technique?

Performa 6400, Mac OS 9.1.x

Posted on Dec 8, 2008 3:56 PM

Reply
2 replies

Dec 8, 2008 5:45 PM in response to R_55a

7.5.3 and later File Sharing
Any Mac running 7.5.3 or later can share the files of any Mac running OS 9 or later using built-in File Sharing using IP. What is not supported beyond 10.3 is File Sharing via AppleTalk. In addition, Sharing initiated from your 10.4 or later Mac to a Mac before OS 9 is not supported directly. So you will have to make the connection from the Older Mac end. Alternatively, you could install "Shareway IP" (a low-cost utility) on the older Mac and connect from the newer Mac.

The 6400 sometimes has trouble when connected to another computer directly, rather than through a Router, Switch, or Hub. The 6400 often has to be connected to an Active Ethernet port AT 6400 STARTUP, or its Ethernet port cannot be selected in the TCP/IP Control panel.

A good general description of this sort of connection process appears in this illustrated article:

Car1son's OS 9 to OS X 10.3 File Sharing Setup


Several links near the top of the page point back at Apple KnowledgeBase articles for network setup, etc.

Message was edited by: Grant Bennet-Alder

connect MacBook to Performa 6400

Welcome to Apple Support Community
A forum where Apple customers help each other with their products. Get started with your Apple ID.