port 3238 and 3283

Question

port 3238 and 3283

I found the comment as below when I open firewall setup for Apple Remote Desktop in Sharing of System Preference on 10.4.2.
'... you allow the service access through the firewall on TCP port(s) 3238 and UDP port(s) 3238. ...'

When I use ARD 1, need to open 3283 UDP. And works fine. Does Apple change this port on 10.4.2? If is is, do I need to open 3238(TCP) and 3238(UDP)?

Posted on Sep 8, 2005 4:31 PM

Reply

Answer 1

Sep 8, 2005 4:50 PM in response to seiichi nakanome

First, note that you
b must
upgrade to ARD 2.2 if you want to control a Tiger (10.4.x) system.

And it is still port 3283 TCP and UDP. For ARD 2, you also need to open port 5900 TCP for control/observe, and 5988 TCP for WBEM (reports).

Reply

Answer 2

Sep 9, 2005 2:42 PM in response to Robert Jacobson1

Also I found need to open port 3283 TCP and UDP, 5900 TCP and UDP for ARD 2.0 and 3283 UDP for ARD 1.2. in the 10.4 server. But I cannot find to open 3238 TCP and UDP. Is there any differences between 10.4 server and client?

Reply

Answer 3

Sep 10, 2005 2:10 PM in response to seiichi nakanome

Is there any differences between 10.4 server and client?

Yes, on the server, there's probably not a checkbox for it. You have to define the rule yourself. Open Server Admin and connect to your server. Click the Firewall section, click the Settings button and make sure the General tab is open.

Under "IP Address Group" highlight "any". Then on the right, scroll down until you see "Apple Remote Desktop 3283", and check the box. Save the settings.

Reply

Answer 4

varjak paw

Level 10

182,668 points

Sep 12, 2005 1:30 PM in response to seiichi nakanome

The mention of 3238 is a typographical error. 3283 is the correct port.

Reply

Answer 5

MKH

Level 1

35 points

Sep 14, 2005 10:32 PM in response to seiichi nakanome

Is there any way to forward UDP ports on an Airport Extreme Base Station?

Reply