Hi all, I added SDD in my iMAC iMac (27-inch, Late 2013) to convert it into fusion drive. All was done with extra care. Connecting display screen back , I can only get 2/3rd screen working with no obvious issue and right 1/3rd remains dark and not showing any signs or display. Could anyone help ,please.
Thank you
Have you done a PRAM reset, CMD+Option+p+r...
http://support.apple.com/kb/HT1379
In fact, do 3 in a row, takes a bit of time.
Intel-based Macs: Resetting the System Management Controller (SMC)...
http://support.apple.com/kb/HT3964
boot into the Recovery volume (boot with the Command + R keys held down), select Disk Utility and run First Aid on the drive. Reboot normally and check to see if the problem persists.
If it does reboot into the Recovery volume and reinstall the system.
It's still same
Please see a screen shot
Thank you for your time and advice. I have tried these options but problem not resolved..any other recommendations ,please
Safe Boot, (holding Shift key down at startup), does the problem occur in Safe Mode?
SCREEN DISPLAY ONLY SHOWS 2/3RD OF SCREEN
