Hi! been trying to find out how to get jog wheel to snap to start of bar rather than to division i stopped sequencer at e.g if i stop at say the 5th 16th of a bar and move to next bar with jog it snaps to same , pain?? thanks Ronny.
G5 2GHz,
Mac OS X (10.3.9),
logic pro 7.1.1 1.5gb ram. 828mk2
Hi justin tried a few things no joy, contacted mackie they say it's a logic snap to issue, I had gathered that. Do you know how to get in touch with apple? can only seem to find FAQ. Thanks Ronny.
Try adjusting the snap value in Logic. If it is set to "smart" then the snap value intelligently changes with the present zoom resolution. So, if you want your MCU jog wheel to snap to the next bar change the snap value in logic to "bar" or adjust your zoom resolution.
I just recently sold my MCU so I don't exactly remember how to change all of the settings.
Also, you can go to Logic Pro, Preferences, Control Surfaces, Preferences and see if the "jog resolution depends on horizontal zoom" is enabled.
for a while I thought you were talking about an input device, not a control surface. There is a Logic feedback, and there is the phone support. Feedback is probably what you want to hit if Mackie confirms incompatability. Otherwise you can assign keys to the commands I suggested-though workarounds are not all too fun.
Thanks for your help but not having any joy on this one. snaps to bar if go back to bar -5 but thats not an option, the other it to use [ or ] and then jog wheel which isn't to bad i suppose. Will try feedback. Pretty sure this wasn't on logic 6. Thanks agian folks Ronny.