Asus Wifi Router Setup

Please take note of these settings if you have a Asus Wifi Router. I owned a ASUS TUF AX3000 Wifi Router.

Some of the settings are somewhat similar with other Asus Wifi Router.

Unable to Connect to the Internet. Red LED Light on the left side of the router. Go to the Router Settings, Go to Lan, IPTV, Select a Lan port, Select ISP Profile to None. Choose IPTV STB port to None.

Go to WAN, Basic Config to Automatic IP (DHCP) for DHCP. Go to WAN, Special Requirement from ISP, DHCP query to Aggressive Mode, Go to uPNP to DISABLE.

Go to Wireless, general disable Enable Smart Connect. (You can enable them without any problems but if you go into disable Enable Smart Connect you need to take note of these settings)

If you are not using AX Wireless you can disable the 802.11ax. General Bandwidth Enable or Disable 160Mhz. General control set to Auto and select Auto select channel including DFS Channel.

If your Wifi does not support DFS Channel. It is advisable to DISABLE the 160Mhz and DFS Channel. And select control channel to 40 Mhz, protection manage frames to Capable. That will get old wifi devices to connect to your network and including if you are using Raspberry Pi.

This is an Optional but if you need to, you can set Wifi Agile Multiband to Enable and Channel Extension to Auto.

Make sure you change your admin account, so that you can remember them and Make sure you update the Firmware Router if Asus have release a newer version.

If you hooked up to the router and it cannot detect the network. Make sure the RJ45 is connect in the router to your mac and reboot your Mac OS. To get the Ethernet detected. Otherwise you will get Self-Assigned IP Address.

Send feedback to ASUS, if you encounter problems with your Asus Router.