Printer Not working after Ventura 13.0 update

Me too , CannonMG3570 not woking after I change to ChipM1 with Ventura.

Hi parinya69,

Not many people will see your post on page 6 of an old thread. You should try to start a new topic via the Ask the Community link above.

However, the Canon MG3570 is listed in About AirPrint - Apple Support as an AirPrint-supported model. You should not need any additional printer drivers when using an AirPrint printer. This provided that the Mac is connected to the same network (Wi-Fi router) as the printer.

If necessary, try to reset the printing system and then re-add the printer to use AirPrint:

Reset the printing system on your Mac to solve a problem – Apple Support (UK)

Add a printer to your printer list so you can use it on Mac – Apple Support (UK)

As always, make sure that you have backup copies of all important files before testing anything.

The following guide from Canon UK (for similar models, such as the MG3550) could perhaps be of interest to you:

https://www.canon.co.uk/support/consumer_products/apple_airprint_guide/

I spoke to Canon and they said to try the Catalina drivers, this didn't work so on a hunch, I downloaded the Mac OS 10.14 Mojave and my Pixma IX6550 printer is now working perfectly.