I felt like I was getting radiation burn every night I looked myself in the mirror and my face and arms were tan, but didnt go out to the sun, very strange, I also felt dizzines or brain fog a little as well as blurred vision so I decided to get an EMF tester and tested the Imac, it marked extreme levels at 55cm away, at 65cm marked severe radiation levels.
Click the displays option is System Preferences, Click colour, Change the colour from Generic RGB Profile to sRGB IEC61966-2.1 and that should fix the radiation issue which is caused by a Auto-Contrast issue!
Click the displays option is System Preferences, Click colour, Change the colour from Generic RGB Profile to sRGB IEC61966-2.1 and that should fix the radiation issue which is caused by a Auto-Contrast issue!
..Mr__Z..
Perhaps protective shield may be assembled from boxes of table salt, or block Salt?
There are supply sources for salt lick blocks these could be cut into shapes.
https://duckduckgo.com/?q=salt+lick+images&t=ftsa&iax=images&ia=images
..Just ideas, if not too unconventional; since salt crystals are already out there..
I understand that, however I tested it on my fathers Imac as well that I gave to him and has the exact levels, so is not an issue on my Imac only, also when the Imac is turned off it still emits large quantities of radiation, both Imacs behave the same, the only way to stop it is actually removing the power chord. No 5g or 4g towers can be found nearby, the data I am getting only shows up when the Imac is plugged in, otherwise no radiation can be found.
OK, here you go, first pic is on, second off and third unplugged:
Yes, putting crystals in between the computer and myself was the only thing I found that somewhat helped even larger salt crystals would do the trick.
Share this information with your nearest Apple Store, or Apple Certified Service Center. Nothing as fellow users we can do about this issue. Do you have a cell phone with 5G radio nearby that may have been the real source of the EMF, and not the Mac?
Consider reducing the cables to those you are immediately using and preferably fully disconnect and remove those you are not using, check the cables for issues—that USB-B cable looks worn—and also consider removing the aluminum foil from the immediate area?
thank you, I tied changing the brightness, no matter how hi or low is even if the Imac is powered off still emits large quantities of radiation, I will try nightshift but I suspect that wont make a difference as it still emits it when the Imac is turned off
Yes, I checked on it, thank you, yes the cables emit radiation I have tested evertyhing but is not nearly compared to the amount this Imacs are emitting, I tried with alluminum foil as you can see in the picture, it barely makes a diference as most of the radiation is coming from the center of the screen as well as the right lower side, but basically from all over the screen even when is off, it only stops when the Imacs are disconected from the outlet.
That value is meaningless in regards to the iMac unless you also have a value with the computer powered off or even unplugged. The difference between the two values is what the iMac is contributing/producing.
You are sitting in front of a window even if the window is partially blocked. You will still get some sunlight effects even if you are not in the direct sunlight.
Thank you for participating in the Apple Support Community.
We want to make sure you reach the right team for help with your device. We recommend that you contact Apple Support directly. Depending on your region, you may be able to reach them here: Get Support.
1) Turn the display brightness down.
Change your Mac display’s brightness - Apple Support
2) Consider enabling NightShift.
Please take a look at the pictures I shared
Other than unplugging, did you find anything that helped while using?
Radiation levels on my Imac
