Your ipad couldn't be activated

Start here >>> If you can't activate your iPhone or iPad (Wi-Fi + Cellular) - Apple Support

If you are experiencing difficulties with (re)activation of your iPad, you may have more success if you connect your iPad to a Windows PC (with iTunes for Windows installed) or a Mac (with iTunes or Finder - as appropriate for the installed version of macOS). Once connected to your computer, your iPad will be detected - and you should be able to activate using iTunes.

1. Make sure that you have the latest version of macOS or the latest version of iTunes.
2. Check that your computer has an Internet connection.
3. With the cable that came with your iPad, connect your iPad to your computer. Locate your device on your computer.
4. Wait while your computer detects and activates your iPad:

• If you see an alert that shows "Set up as New" or "Restore from Backup", it means your iPad is activated.
• If you get an error message that says the "activation information was invalid" or "activation information could not be obtained from the device", use recovery mode to restore your iPhone.

A restart of your WiFi Router and/or a change of DNS settings may also be helpful.

To restart you home router, disconnect power - then wait at least 30 seconds before restarting. When you router has rebooted (which may take several minutes), force-restart your iPad:

Force restart iPad (models with Face ID or with Touch ID in the top button)

If your iPad doesn’t have the Home button, do the following:

1. Press and quickly release the volume button nearest to the top button.
2. Press and quickly release the volume button farthest from the top button.
3. Press and hold the top button.
4. When the Apple logo appears, release the top button.

Force restart iPad (models with the Home button)

Press and hold the top button and the Home button at the same time. When the Apple logo appears, release both buttons.

For recommended DNS servers (configured at your home router and/or your iPad), you might choose one of the following Recursive DNS Providers (IPv4 and IPv6 addresses included below):

Quad9

9.9.9.9

149.112.112.112

2620:fe::fe

2620:fe::9

OpenDNS

208.67.222.222

208.67.220.220

2620:119:35::35

2620:119:53::53

Cloudflare

1.1.1.1

1.0.0.1

2606:4700:4700::1111

2606:4700:4700::1001

Should it be necessary to escalate your issue to Apple Support, the quickest route to engaging with Apple Support will be via the Support link at top-right or bottom-left of this page.

You should check this article: If you can't activate your iPad - Apple Support. If you can't activate your iPhone or iPad (Wi-Fi + Cellular) - Apple Support

If your iPad is a cellular model, some have reported that temporarily removing the sim allows activation to complete.

Otherwise, 5 possible causes for that error message:

1] Activation server is actually down. Very rare occurrence, and of short duration when it

does happen. Solution - try again.

2] Your firewall and/or antivirus software are preventing the necessary connection. Solution -

temporarily disable your firewall and/or antivirus software until the activation completes.

3] computer being used for activation has been used to jailbreak an iOS device in the past.

Solution - use a different computer.

4] iPad has been jailbroken. Your favorite search engine may provide some direction, but jailbreaks often prevent

activations/updates from succeeding. Per Terms of Use for this forum, discussion of jailbroken iPads is

prohibited.

5] your region and/or timezone settings are inconsistent with your actual location. Solution - set region and/or timezone correctly.

Anecdotes in the forum say that Apple has changed the way the activation server is contacted and that older iPads on obsolete versions of iPadOS can no longer reach the server. Others have said connecting their old iPad to a Mac or PC to activate thru the computer helps.

Hey I would recommend taking this to your local Apple Store to have a look