Attach display port cable in mid 2010 IMac

Question

Level 1

4 points

Attach display port cable in mid 2010 IMac

I recently decided to replace my old hard drive with a SSD in my mid 2010 Imac. After watching a lot of you tube videos, I opened up the Imac and installed the SSD without any difficulty. However when I opened up the Imac the Display port cable came off by itself, something I did not intend to do. Now, despite watching every video I can find, I have been unable to reinsert the ribbon cable into its slot. My ribbon cable has a tab that is supposed to be moved when removing the cable. I would appreciate any advice on reinserting the dispay port cable

Posted on Oct 17, 2024 8:46 AM

Reply

Answer 1

Top-ranking reply

D.I. Johnson

Level 7

24,251 points

Oct 17, 2024 9:07 AM in response to jimfromva

Ah! The joys and hazards of DIY.

As I recall, reinstalling this ribbon can be a little tricky because it isn't especially long and the screen will be hovering within inches of the logic board as you do it. You might recruit an assistant with smaller hands to slip that cable back into the slot and close that tab.

Take a look at this guidance found at OWC/macsales.com.

Reply

Answer 2

Oct 17, 2024 11:42 AM in response to jimfromva

You're welcome. 🙂

And I'm pretty sure the cable is parallel to the board, not at an angle.

Reply

Answer 3

jimfromva Author

Level 1

4 points

Oct 17, 2024 10:30 AM in response to D.I. Johnson

Thanks DI, I tried to reply but not sure it went thru. I have previously looked at the referenced video, but can’t tell if the cable is inserted parallel to the board or at an angle. However the real problem is probably hand size and age. I may have to get my grandson to help.

Thanks again

jim

Reply

Answer 4

jimfromva Author

Level 1

4 points

Oct 21, 2024 12:22 PM in response to D.I. Johnson

Thanks, I’m sure you are correct. I noticed that you can buy replacement cables on ebay, which made me realize you can disconnect the cable at the lcd screen as well. I did that and removed the whole lcd screen. Now it should be easier for my fat hands the slip the cable into the board with that funky tab, and then attach the end at the screen near the end of reattaching the 4 cables and wires . Its pretty easy to attach the data cable to the screen. I ordered a new data cable just to make sure my cable is in good shape.

Reply

Answer 5

Oct 21, 2024 12:32 PM in response to jimfromva

That's good news, my friend. I hope you finish this project without any other hiccups.

Thank you for the update! 🙂👍🏽

Reply