Battery Not Charging after 10.6.8 Update, Battery Not Charging after 10.6.8 Update

seems it was a coincidence that you upgraded and battery was kaput. Your cycle count is 662 so the threads below is what makes me think it was a coincidence

https://discussions.apple.com/thread/1177772?start=0&tstart=0

Also below links will be a good guide too

http://www.apple.com/batteries/replacements.html

System Profiler>Power. Post your battery information from the right side column.

Hi!

Same problem since my GF updated her MB 2.4 C2D to 10.6.8

"Not charging" / "Replace now"

Even though battery has 566 cycles, it worked well before upgrading. So I don't think that's a coincidence.

I'm gonna try to contact an Apple Store in Paris and see what they say...

If any news on your side, just let me know 🙂

Informations de la batterie :

Informations sur le modèle :

Fabricant : DP

Nom de l’appareil : : ASMB016

Pack Lot Code : 0002

PCB Lot Code : 0000

Version du programme interne : 0110

Révision du matériel : 0500

Révision de pile : 0200

Informations sur la charge :

Charge restante (mAh) : 0

Charge complète : Non

En cours de chargement : Non

Capacité de charge complète (mAh) : 0

Informations sur la santé :

Comptage de cycles : 566

Conditions : Remplacer maintenant

Batterie installée : Oui

Intensité de courant (mA) : 0

Tension (mV) : 8232

I updated this afternoon and my battery doesn't charge now either. Here's the battery information:

Battery Information:

Model Information:

Manufacturer: DP

Device name: ASMB016

Pack Lot Code: 0002

PCB Lot Code: 0000

Firmware Version: 0110

Hardware Revision: 0500

Cell Revision: 0102

Charge Information:

Charge remaining (mAh): 0

Fully charged: No

Charging: No

Full charge capacity (mAh): 0

Health Information:

Cycle count: 365

Condition: Replace Now

Battery Installed: Yes

Amperage (mA): 0

Voltage (mV): 8907

My cycle count is half that of the other posts on this page. It held a full charge a week ago when I last used it. SMC reset had no effect. Does anyone know what else I can do?

I am very frustrated. I just picked up my 8 month old 13" Macbook Pro today from the Apple Store after they had to replace a faulty logic board. I ran a software update this afternoon and installed the Mac OS X version 10.6.8 update (Build 10K549) and now noticed that my battery is "not charging" but for the time seems to be holding at 29%, and my green light, that is normally on, is not on.

I already did the SMC reset. No change.

Please help if you can.

Battery Information:

Model Information:

Serial Number: 9G0430CFYD3MA

Manufacturer: DP

Device name: bq20z451

Pack Lot Code: 0000

PCB Lot Code: 0000

Firmware Version: 0201

Hardware Revision: 0002

Cell Revision: 0158

Charge Information:

Charge remaining (mAh): 1553

Fully charged: No

Charging: No

Full charge capacity (mAh): 5417

Health Information:

Cycle count: 74

Condition: Normal

Battery Installed: Yes

Amperage (mA): 0

Voltage (mV): 11297

System Power Settings:

AC Power:

System Sleep Timer (Minutes): 60

Disk Sleep Timer (Minutes): 10

Display Sleep Timer (Minutes): 60

Wake On AC Change: No

Wake On Clamshell Open: Yes

Wake On LAN: Yes

Current Power Source: Yes

Display Sleep Uses Dim: Yes

Battery Power:

System Sleep Timer (Minutes): 60

Disk Sleep Timer (Minutes): 10

Display Sleep Timer (Minutes): 60

Wake On AC Change: No

Wake On Clamshell Open: Yes

Display Sleep Uses Dim: Yes

Reduce Brightness: Yes

Battery Not Charging after 10.6.8 Update

Hi

breaking news : the battery almost "burned", it is not even fitting in its slot anymore. It was still plugged in and "not charging"...

i hope it did not burn any other component...

Replace the battery now is indicated.