-
All replies
-
Helpful answers
-
Oct 26, 2011 10:25 AM in response to Backphlipby putneytower,I experience a similar issue. However, reception (both voice and data) does not return until after I have removed the SIM and put it back in. As a part of the upgrade (that's why I have the phone), I was provided with a new SIM but I experience the same issue.
Any ideas?
Thanks.
-
Nov 13, 2011 3:02 PM in response to putneytowerby realist615,I've experienced the same issue except I haven't messed with the sim card. I think it's probably a bug in IOS5. I don't think the dual antennas were tested so well.
-
Dec 22, 2011 4:15 PM in response to Backphlipby LebanonDeek,I've had the exact same issue that started right after I accepted a software update for IOS5!?!
Whenever I turn the phone off and back on, or take out the sim card and put it back in...I get reception long enough to send one sms or make one phone call and then I loose all reception.....
And it's not the sim card because i tried it in my wife's iphone.
I also think that my Siri has been a little off since the update as well.
-
Dec 22, 2011 4:30 PM in response to Backphlipby LebanonDeek,Someone suggested to me:
Fix iPhone 4S network issue by disabling PIN code request in micro-SIM
Here's the link to the full article:
Unfortunately, this did not work for me :-( I still have the same problem...But i hope this can help some of you..
-
Dec 28, 2011 8:59 AM in response to Backphlipby LebanonDeek,Dear all,
(THIS CONCERNS MTC TOUCH CUSTOMERS IN LEBANON)
I've received an email with a solution to the problem; you have to update to the new iOS 5.0.1 firmware (9A406)!! It's been 1Hour and so far my iPHone 4S is working just fine. Please follow carefully the below instructions:
RUN A FULL BACK UP BEFORE DOING ANY OF THIS
1. Download the new iOS 5.0.1 firmware (9A406) from the internet. (800MB)
2. Connect your iPhone 4S to iTunes.
3. Once connected, two options will show: ‘restore’ and ‘check for update’.
4. Press down SHIFT and choose ‘check for update’. (if you click ‘check for update’ without pressing down SHIFT doesn’t work.)
5. Select the new firmware (9A406). Note that the file should be renamed ‘iPhone4,1_5.0.1_9A406_Restore.ipsw’ (instead of ‘iPhone4,1_5.0.1_9A406_Restore.zip’), i.e. changing the file extension from ZIP to IPSW. iTunes will now work alone and update your iPhone 4S.
A full back up is recommended before firmware upgrade.HOPE THIS HELPS