Looks like no one’s replied in a while. To start the conversation again, simply ask a new question.

Setting up build so that one bullet point replaces the previous one.

Hi all,


This seems like this should be super easy, but I just cannot figure out how to make it happen.


In a single slide, I'd like to build a bullet list so that each click causes the next bullet point to replace the previous one. (Thus, only one bullet point would be onscreen at a time, each in the same location.)


Click 1:


blah blah blah

•bullet 1



Click 2:

blah blah blah

•bullet 2


...and so on...


Any thoughts? Thank you!

Posted on Oct 30, 2011 7:54 PM

Reply

There are no replies.

Setting up build so that one bullet point replaces the previous one.

Welcome to Apple Support Community
A forum where Apple customers help each other with their products. Get started with your Apple ID.