dot1x authentication
Scenario:
Mac running 10.4.4 (also occurs 10.3.9)
keychains:
CA certificate is installed in the Anchors (certificate is good)
User certificate is installed (certificate is good)
Both certifiates are set to Fully Trust.
Plug into switch which is running dot1x. Windows PC with same certificates authenticated fine. MAC doesn't.
In the dot1x settings i cannot select TLS due to error message "Turning on TLS will cause authentications to fail. TLS can't be enabled because your key chain does not contain any suitable certificates".
Mac running 10.4.4 (also occurs 10.3.9)
keychains:
CA certificate is installed in the Anchors (certificate is good)
User certificate is installed (certificate is good)
Both certifiates are set to Fully Trust.
Plug into switch which is running dot1x. Windows PC with same certificates authenticated fine. MAC doesn't.
In the dot1x settings i cannot select TLS due to error message "Turning on TLS will cause authentications to fail. TLS can't be enabled because your key chain does not contain any suitable certificates".
Mac OS X (10.4.4)
