KyoceraMita Scanner Interfase NS-30

Question

KyoceraMita Scanner Interfase NS-30

KyoceraMita Scanner Interfase NS-30 + KMScanToMac v1.3.0707
Powermac G4 and G5
Our scanner has run without problems until Tiger came along.
We had a short breakdown with Jaguar where we minged with the permissions of the target folder that the scanner is sending to.
Installing Tiger gave us problems again and permissions did not do it any longer.
We kan se the IP scanner in Safari but we can not send from the scanner to the computer.
We have checked the IP adresses in both computer and scanner. They should be ok.

G4 G5, Mac OS X (10.4.5)

Posted on Feb 21, 2006 8:18 AM

Reply

Answer 1

bob71852

Level 1

0 points

Feb 23, 2006 10:27 AM in response to Mogens Riis Laubjerg

Ask your Kyocera Mita dealer to contact their Tech Rep from KMA to get a newer Scan utility. If the Tech Rep doesn't know about it have him ask his Regional Manager. I don't believe it has been generally released yet. The version is 1.3.1010

Reply

Answer 2

Feb 24, 2006 2:57 AM in response to bob71852

Thank you Bob
The Scanner is working now, but there there was another problem that had to be solved and I stumbled over solution when installing Scan to MacOSX 1.3.1010. When yoru are using the installer the dialog box comes up i rubbish. Its is a language I dont know. We had this problem earlier and had to swift from Danish to British language i the system prefs. Then the installer comes up with the right dialog box in english.
The installation runs.
This time, different from previus times I forgot to swift back to Danish language.
The scanning worked fine.
When swifting back to Danish the could not find the mac i was supposed to scan to.
I have now gone back to English and the scanning is working fine. It must therefore be a language specific problem. I have given the discussion link to the lokal KCM. Again thank you fore your help

Reply