You may use these instructions which do not require anything but Disk Utility:
INSTALLING A NEW HDD IN A MBP.
1. Make certain that you have backed up all of your important data.
2. You will need a HDD enclosure. One with a USB connection will do. A 9 pin Firewire is better.
3. Install your new drive in the enclosure and connect it to your MBP.
4. Open DISK UTILITY>ERASE. From the left hand column drag the new drive into the 'Name' field. Make sure that the format is 'Mac OS Extended (Journaled)'. Click on the 'Erase' button.
5. Click on the 'Restore' button (on top). Drag the old drive into the 'Source' field and the new drive into the 'Destination' field. Click on the 'Restore' button on the bottom right hand corner.
Depending upon the amount of data you are transferring, this may take a couple hours or more. A Firewire will speed up the transfer. This will result in both drives having identical information on them.
6. After the data transfer has completed, you may test the new HDD by starting your MBP with the OPTION key pressed down. Select the new HDD and see if it working to your satisfaction. If so, swap the drives. Start the MBP and you have finished the installation. The initial boot may take a bit longer than you are accustomed to, but that is normal.
7. When you are satisfied that the new hard drive if functioning properly, you can erase the old drive and use it for any needs that you may have.
I am assuming that the current 500 GB Seagate is using less than the capacity of the new Crucial SSD.
Ciao.