Thunderbolt Firmware Update v1.1

Question

Level 1

18 points

Thunderbolt Firmware Update v1.1

Hi,

I saw a software update for the Thunderbolt Firmware Update v1.1 on the Mac App Store (http://support.apple.com/kb/DL1612). I updated it but yet it keeps appearing on the App Store. I dont' know why. And, I encountered another issue with this update. When the system requires me to restart my laptop after supposedly updating the firmware, my laptop restarts twice and it takes a much longer time than normal to restart. Furthermore, after this supposed update, my laptop takes longer than normal to boot up. Does any one of you face the same problem? Could anyone help ease my worry? Thank you!

Han Min

MacBook Pro, OS X Mountain Lion (10.8.2)

Posted on Nov 28, 2012 6:04 AM

Reply

Answer 1

Allinray

Level 1

0 points

Nov 29, 2012 8:10 AM in response to Danlibripark

Yes, I have the same exact problem. You are not alone.

Reply

Answer 2

Nov 29, 2012 3:49 PM in response to Danlibripark

me too, after installing [mbp 13" june 2012], it reboots 2 times and the update is still in the appstore.

Reply

Answer 3

Dec 22, 2012 4:59 AM in response to Danlibripark

OS X Mountain Lion: Firmware updates may keep reappearing in the Mac App Store

To address the issues and find the solutions for your problems, ... visit the following link

http://support.apple.com/kb/TS4422

Hope this resolves your issues.

Reply

Answer 4

Dec 22, 2012 5:43 AM in response to Adel Sabry

Is it possible that the needed update isn't on the page?

we need thunderbolt firmware update 1.1, that's not the same as thunderbolt display firmware i think,

because when I try to run de display firmware it says "already installed"...

Reply

Answer 5

Jan 1, 2013 5:58 AM in response to Danlibripark

Hi there,

I had the same problem and tried it a million times.

But the solution was simple.

I have two partitions, a MacOS- and a Windows-Partition. The Windows partition is the start volume. And this was the problem. After restarting I had to press "alt" to chose the volume manually.

Some of the needed installation information seemed to got lost doing this. For the first time. All other updates worked fine.

So I only had to set MacOS as start volume and redtried it successfully.

Good luck,

Kay

Reply

Answer 6

Jan 1, 2013 8:22 AM in response to Danlibripark

installing the update with the magsafe powerconnecter connected to my macbook solved the problem for me

Reply

Answer 7

Jan 3, 2013 6:48 AM in response to Thorsten-Kay

this solved it for me,

thanks!

Reply