How do I set autopunch locators to smaller increments than beats per bar?

Hi

You could adjust it in the Bar Ruler whilst holding down Control.

You could customise the Transport (Control Click on it) and enable "Sample Rate or Punch Locators". You can then set the Auto Punch locators manually.

CCT

Hi

bob.logan64 wrote:

Is this in the manual somewhere? The manual doesn't say anything about the holding down control.

I've had a quick look:

Not specifically in the Autopuch section, other than you can adjust the locators in a similar way to Cycle locators

http://documentation.apple.com/en/logicpro/usermanual/index.html#chapter=14%26se ction=15%26tasks=true

The Cycle locators section does not mention it

But

The Moving regions section does mention it:

http://documentation.apple.com/en/logicpro/usermanual/index.html#chapter=13%26se ction=13%26tasks=true

You could also use the Marquee tool to set the Autopunch locators.

bob.logan64 wrote:

Also I'm having trouble with fades. I'm using the fade tool, but it always start at a certain point. And I want the fade to be less than where it always initially starts. Is the something I can do to control the whole fade? Is there something I should be holding down while dragging the fade tool?

You might fair better to post this as a new topic, but one solution would be to zoom in, another to set the fade length numerically in the Region parameters box in the Inspector.

CCT