Error code -50

Question

Level 1

0 points

Error code -50

My ipod touch recently wiped itself clean after trying to update, but now whenever I try to restore it, it goes partially and pops up saying error code -50 has occured. Can anyone help me, and if so it would be greatly apprieciated.

iPod touch

Posted on Apr 20, 2013 5:03 PM

Reply

Answer 1

lllaass

Level 10

210,411 points

Apr 21, 2013 3:09 AM in response to recoded9

Error 13, 14, 35 and 50 (or -50)

These errors are typically resolved by performing one or more of the steps listed below:

Perform USB isolation troubleshooting, including trying a different USB port directly on the computer. See the advanced steps below for USB troubleshooting.
Put a USB 2.0 hub between the device and the computer.
Try a different USB 30-pin dock-connector cable.
Eliminate third-party security software conflicts.
There may be third-party software installed that modifies your default packet size in Windows by inserting one or more TcpWindowSize entries into your registry. Your default packet size being set incorrectly can cause this error. Contact the manufacturer of the software that installed the packet-size modification for assistance. Or, follow this article by Microsoft: How to reset Internet Protocol (TCP/IP) to reset the packet size back to the default for Windows.
Connect your computer directly to your Internet source, bypassing any routers, hubs, or switches. You may need to restart your computer and modem to get online.
Try to restore from another known-good computer and network.

Reply