[NAND] _FindFlashMadiaAndKeepout; 429 physical nand block offset 16
[NAND] start:220 this 0x84646c00 PROVIDER 0x845b3900 FlashMedia=0x845b3900
[NAND] wmr_start:149 Apple PPN NAND Driver, read/write
[NAND] WMR_Start:174 FiL_Init [OK]
How do I fix it or is it a paper weight now.
iPad 2
Take a look at this link, http://support.apple.com/kb/TS3274
Take a look at this link, http://support.apple.com/kb/TS3274
Eric, I have done all of those...any other ideas.
Try this link, http://support.apple.com/kb/HT4097
Eric,
I did what the link indicated and restored it.
However, a few mintues after it restored i got the same message.
Any ideas?
Hi, my ipad 2 just got the same problem and after reading all relative post, finnally i figrue it out, that is no software issue at alll just hardware,
I did attemp replace the power button cable on my ipad so i must disconnect the back camera cable so there is my problem. Because the connect some how not exact in place, i took the camera out and the issue is gone. So, in your case, if you did try to replace anything look at them again or you just take them out one by one and reboot ipad until it work.
Hope this help
Binh
I tried to restore my ipad and I got this message
