Trackpad Hypersensitive

With tap-to-click disabled, there are sporadic spontaneous undesired clicking events when the trackpad is touched but not pressed.


This is actually worse than tap-to-click because it clicks even when the finger is sliding around.

It renders the trackpad virtually useless because it takes some much attention and corrective effort to undo all the clicks.


The problem happens when the cpu is under load and when the computer is somewhat hot.


This problem has gradually become apparent and is gradually getting worse.


The problem was not reproducible at the genius desk so I left there with tail between legs.


If you know a way to fix it, please let me know. Otherwise if someone else has the same issue we can form a support group.

MacBook Air, OS X Mountain Lion (10.8.4)

Posted on Aug 12, 2013 11:35 AM

Reply
3 replies

Aug 12, 2013 1:09 PM in response to pizayu

There are several possible causes for this issue. Take each of the following steps until it's resolved.

1. Follow the instructions in this support article.

2. Open the Bluetooth preference pane in System Preferences and check for unknown or forgotten input devices. Disconnect any USB input devices that you aren't using.

3. Boot in safe mode and test, preferably without launching any third-party applications. If you don't have the problem in safe mode, but it comes back when you reboot as usual, stop here and post your results. If you can't boot in safe mode, do the same. If you booted in safe mode and there was no change, go on to the next step.

4. Reset the System Management Controller.

5. If you're using a Bluetooth trackpad, investigate potential sources of interference, including USB 3 devices.

6. A swollen battery in a MacBook Pro or Air can impinge on the trackpad from below and cause erratic behavior. If you have trouble clicking the trackpad, this is likely the reason. The battery must be replaced.

7. There's a report that a (possibly defective) Thunderbolt Ethernet adapter can cause the built in trackpad of a MacBook to behave erratically. If you're using such an adapter, disconnect it and test.

8. There's also a report of erratic cursor movements caused by an external display that was connected but not turned on.

9. If none of the above applies, or if you have another reason to think your computer is being remotely controlled, remove it from the network by turning off Wi-Fi (or your Wi-Fi access point), disconnecting from a Bluetooth network link, and unplugging the Ethernet cable or USB modem, whichever is applicable. If the cursor movements stop at once, you should suspect an intrusion.

10. Make a "Genius" appointment at an Apple Store to have the machine tested.

This thread has been closed by the system or the community team. You may vote for any posts you find helpful, or search the Community for additional answers.

Trackpad Hypersensitive

Welcome to Apple Support Community
A forum where Apple customers help each other with their products. Get started with your Apple Account.