HT203477: Final Cut Pro X 10.1 and later: Troubleshooting basics
Learn about Final Cut Pro X 10.1 and later: Troubleshooting basics
-
All replies
-
Helpful answers
-
Aug 13, 2013 8:40 AM in response to Stefan50by Tom Wolsky,Double click the transition and open it in the precision editor. Post a screen shot.
-
Aug 13, 2013 8:42 AM in response to Stefan50by Russ H,Double click on the edit point. Is there sufficient additional media that would allow you to make the change?
Russ
-
-
Aug 13, 2013 10:55 AM in response to Stefan50by Tom Wolsky,That's not the precision editor. You've double-clicked the audio waveforms. Zoom in a bit and double-click the transition.
-
Aug 13, 2013 10:56 AM in response to Tom Wolskyby Stefan50,Hi Tom, thank you for taken interest in my case
-
-
-
Aug 13, 2013 11:08 AM in response to Russ Hby Stefan50,I think it is, because if I remove the clip the dissolve for the next clip stays 2 sec
-
Aug 13, 2013 11:14 AM in response to Stefan50by Tom Wolsky,Yes it is, and it shows that the incoming clip, below the center bar, has no additional media that allows you to extend the transition. The outgoing clip, above the bar, has plenty, but there's nothing available for the B side. If you want to extend the transition, you'll have to trim some video off the incoming clip.
-
Aug 13, 2013 11:26 AM in response to Tom Wolskyby Stefan50,Thanks it did help. I am most gratefull

