I just purchased the 2TB TC and set it up on bridge mode to my att verse which is connected via ethernet cable. The TC is continually blinking amber and an error message states that a wireless network cannot be found but the uverse is functioning great

Question

Level 1

0 points

I just purchased the 2TB TC and set it up on bridge mode to my att verse which is connected via ethernet cable. The TC is continually blinking amber and an error message states that a wireless network cannot be found but the uverse is functioning great

I just purchased the 2TB TC and set it up on bridge mode to my att verse which is connected via ethernet cable. The TC is continually blinking amber and an error message states that a wireless network cannot be found but the uverse is functioning great. The network name I assigned to the TC is also not appearing among available networks. How do I remedy this, please?

Posted on Jan 3, 2014 5:27 PM

Reply

Answer 1

Jan 4, 2014 1:13 AM in response to timhyun22

What OS on the computer you are using to setup the TC?

Did you turn on ipv6 for wireless to link-local... this is essential for network access now??

Try power cycling the network.. start up in correct order.. uverse.. 2min wait.. TC.. 2min wait.. computer.

No luck factory reset and start over. Use ethernet cable as well to the computer to help it.

No luck I can show you manual method.

Reply