How do I reverse the movement of a replicator?

Question

Level 1

23 points

How do I reverse the movement of a replicator?

Using Motion 5 and have a replicator (Wispy Spiro) for a project. However, the movement of the replicator moves counter-clockwise and I need it to reverse direction to move clockwise. Can't seem to figure out how to do that. Any suggestions?

PS - The project is not in 3D. I can convert it of needed to accomplish what I need.

Posted on Feb 15, 2014 11:50 AM

Reply

Answer 1

Feb 15, 2014 1:50 PM in response to kb8wfh

Select the arcs group in the layers list. Go to behaviors tab in the inspector and adjust the phase sliders for anchor x and y. They are very touchy so try starting around 60 - 65. Make small adjustments until you get what you want. They may not have exactly the same values. Just play the project and adjust as it plays.

Reply

Answer 2

kb8wfh Author

Level 1

23 points

Feb 15, 2014 1:51 PM in response to Jim Wanamaker

Excellent, will give this a try. Thank you.

Reply