I have an Xserve Raid. I recently set it up with my Xserve server with fiber cables and now when the Xserve Raid system boots and starts all the drives show as empty in the Raid monitor. Not sure if I have something configured wrong and I think I shut it down incorrectly before I got it hooked up right. When I first got it I was able to see the lights on all the drives but now it boots but no drives show up at all. I have fiber cables to the host Xserve machine and the Xserve Raid plugged into the network with only 1x ethernet cables (not 2 if that makes a difference). When I try to manage the Xserve Raid all drives show as empty even though all the 500GB drives are plugged in. Not seeing any green lights when the Xserve raid boots indicates something is up. I reset the controller cards to stock with the paper clip to factory settings. Does anyone have any ideas on what to try. Anyone have this issue? I haven't found any discussions except one that had a single side of drives go down because of a bad controller card. My Xserve Raid shows no drives at all. Any help is appreciated.
