When I sequence a new section to an existing part, the last bar of the existing part is often erased.

Question

Level 1

0 points

When I sequence a new section to an existing part, the last bar of the existing part is often erased.

Help please:

When I sequence a new section to an existing part, the last bar of the existing part is often erased. The erased part does not contain any of the new part. I'm using a 2 bar count-in and it does not always do this. There must be a setting somewhere that I'm unaware of.

Thanks, Louise

Logic Pro X

Posted on Apr 22, 2014 2:51 PM

Reply

Answer 1

Apr 22, 2014 3:39 PM in response to Louise1122

I've found this happens if I get out of record before the loop finishes. So, if I'm recording a two bar loop, I let Logic cycle record through to the next iteration and then stop it. Delete the bit that's hanging over.

To set this up, go to File>Project Settings>Recording and in the MIDI section, select "Create Tracks and Mute when Cycling"

Hope this helps!

Reply