Q: inputs availabilty or not present-Logic 9.1.8 upgrade

Hi yesterday I installed Logic Studio(9) for the first time, all went smooth; I opened a project using 9 and recorded some audio through my motu audio interface into its inputs 7&8 and the audio recording seesion all went fine!

...today I followed software update of Logic studio, to 9.1.8

Now I cant get audio "to run into Logic"

Im well use to the recording audio process from Logic 8, I have input enabled or record enabled....etc

but since the update, in yesterdays session, the input options in audio channel are greyed out "stuck" where it was set at 7&8(greyed out)

and there is no audio signal

on opening a new blank project to acess, there is no inputs channels AT ALL available only bus selection options as input....

so this is my first stumbling block with Logic studio, Im a couple of operating systems back: Snow leopard 10.6.8

this was fine yesterday with the intial install like i said, help needed already!