Joseph Kutza

Level 1 (0 points)

Q: iMac 2008 always crashes after 30 minutes.

It won't restart unless I wait an hour. Also crashed after 30 min when in target disk mode. Disk utility said no problems. I'm using system 10.10.3

Posted on Jun 14, 2015 8:18 AM

I have this question too

Solved

Level 6 (17,283 points)

Apple Watch

A:

Failing hard drive. Sorry. But like I said not that difficult to change. https://www.ifixit.com/Guide/iMac+Intel+24-Inch+EMC+2111+Hard+Drive+Replacement/ 5211

Posted on Jun 14, 2015 5:32 PM

Q: iMac 2008 always crashes after 30 minutes.

All replies

Helpful answers

by Mike Sombrio,

Mike Sombrio Jun 14, 2015 8:27 AM in response to Joseph Kutza
Level 6 (17,283 points)

Apple Watch

Jun 14, 2015 8:27 AM in response to Joseph Kutza

You should run the Apple Hardware test from your original gray install discs.
Reply options

Link to this post

by Joseph Kutza,

Joseph Kutza Jun 14, 2015 11:19 AM in response to Joseph Kutza
Level 1 (0 points)

Jun 14, 2015 11:19 AM in response to Joseph Kutza

Thanks, Mike. I ran the hardware test - No trouble found. Any other ideas?
Reply options

Link to this post

by Mike Sombrio,

Mike Sombrio Jun 14, 2015 1:24 PM in response to Joseph Kutza
Level 6 (17,283 points)

Apple Watch

Jun 14, 2015 1:24 PM in response to Joseph Kutza

Run it two or three times in extended mode. AHT isn't the most reliable tool but it's all they give us. When you say your mac crashes what does that mean? Is it having a kernel panic? OS X: When your computer spontaneously restarts or displays "Your computer restarted because of a problem." - Apple Supp…
Post a panic log Mac OS X: How to log a kernel panic - Apple Support
Reply options

Link to this post

by Joseph Kutza,

Joseph Kutza Jun 14, 2015 3:15 PM in response to Mike Sombrio
Level 1 (0 points)

Jun 14, 2015 3:15 PM in response to Mike Sombrio

I should say that it freezes. Just stops, get the spinning beach ball of death... I need to press the power button to turn it off. If I don't wait about an hour before restarting, it freezes during restart. That's maybe the oddest part of the whole thing. When it's "on" I ran disk utility OK. However, after a freeze, if I boot with the OX Install CD, disk utility doesn't "see" the hard drive.
I tried resetting the PRAM just for the heck of it, but it doesn't seem to take because it doesn't like to restart right away (time wasn't affected).
Never seen anything like this one! and thanks again for your help.
Reply options

Link to this post

by Mike Sombrio,

Mike Sombrio Jun 14, 2015 5:16 PM in response to Joseph Kutza
Level 6 (17,283 points)

Apple Watch

Jun 14, 2015 5:16 PM in response to Joseph Kutza

My best guess is that your hard drive is failing. If you haven't you need to back it up NOW before you can't. If you have an external disk that you can install OS X on and boot off of that to test you can either prove or disprove the hard drive failure. It sounds like the drive is getting hot and locking up. Or worse a connection on the logic board is getting hot and opening up.....hope thats not the case. Hard drives aren't difficult to replace.....and you can replace it with a blazing fast SSD if that turns out to be the problem.
Reply options

Link to this post

by Joseph Kutza,

Joseph Kutza Jun 14, 2015 5:23 PM in response to Mike Sombrio
Level 1 (0 points)

Jun 14, 2015 5:23 PM in response to Mike Sombrio

I guessed as much... OK, the extended hardware test showed an error: 4HDD/11/40000004: SATA(0,0)
Reply options

Link to this post

by Mike Sombrio,Solvedanswer

Mike Sombrio Jun 14, 2015 5:32 PM in response to Joseph Kutza
Level 6 (17,283 points)

Apple Watch

Jun 14, 2015 5:32 PM in response to Joseph Kutza

Failing hard drive. Sorry. But like I said not that difficult to change. https://www.ifixit.com/Guide/iMac+Intel+24-Inch+EMC+2111+Hard+Drive+Replacement/ 5211
Reply options

Link to this post