logic keep playing notes out off region

Hi

pinoleone wrote:

In the past i have look on the internet and found a setting in logic that you can put on and then logic will never play notes or sustained notes even out site of the region

Inspector, Region Parameters: Clip Length check box?

CCT

CCTM wrote:

Inspector, Region Parameters: Clip Length check box?

CCT

Great catch CCT 🙂

Nigel

Cut the region using the scissors tool..... instead of just dragging the end of a region to a different length....

That is definitely not the expected behavior.

I would do some standard trouble shooting "to get to the bottom of it":

• Is it only with one Project or all Project?
• Is it only with one Track/Region or all?
• Is there a difference when the MIDI Events are recorded or manually created?
• Loock at the Event List, to see if there is something suspicious
• ...

Hope that helps

Edgar Rothermich - LogicProGEM.com

(Author of the "Graphically Enhanced Manuals")

http://DingDingMusic.com/Manuals/

'I may receive some form of compensation, financial or otherwise, from my recommendation or link.'

Edgar,

What I was guessing is going on.. (and of course, I could be wrong 🙂 ) is that...

The region contains some long notes triggering maybe an Arp or sample..... and when the OP shortens the region by dragging the right hand side.. the note is still being triggered before the end of the region and so the Arp or lSample.. will continue to play past the end of the region..., unless you cut the region and shorten the note(s) as per the dialog box that pops up.....

I did a few tests here and could recreate the OP's observation here if i just dragged the region end.... but not if I cut it....

However, of course, something else might be going on that i cannot recreate and as you said.. that would be unexpected behavior...

To the OP...

That is what i'm doing now but in the past i have found a way to do this but i cant find it anymore.

What exactly are you doing now.... and what did you used to do in the past.. as Im not sure which method(s) you are referring to?

Cheers..

Nigel

Yes, as long as the start of the Note Events is inside the Region range, then it will be triggered (and usuallly cut off at the end of Region if the Note Event is outside the Region range.

When the OP stated that "there is midi data in it that is outside of the region", I assumed the entire Note Events from beginning to end. If that is outside the active Region, then there should be no sound.

When the OP stated that "there is midi data in it that is outside of the region", I assumed the entire Note Events from beginning to end. If that is outside the active Region, then there should be no sound.

Yes.. if that is the case.. then that's what I also call unexpected behavior and is something I cannot recreate here..