-
All replies
-
Helpful answers
-
Feb 16, 2016 2:03 PM in response to diar5714by Tom Wolsky,WWhen you click the blue stabilization box what happens? Does it turn itself off? Running an analysis doesn't turn on stabilization. Checking the box will run the analysis if it's not been done.
-
Feb 16, 2016 2:11 PM in response to Tom Wolskyby diar5714,It turns on, and it starts to analyze. After the analysis and render are done, the blue box goes off.
-
-
-
Feb 16, 2016 4:31 PM in response to diar5714by Tom Wolsky,IM guessing it just can't stabilize it. If the shot is too complex like a tracking shot there's nothing for it to lock onto. You might try CoreMelt's Lock and Load.
-
Feb 16, 2016 4:56 PM in response to Tom Wolskyby diar5714,I hardly doubt it. At the beginning, I had the whole video stabilized. But when I trimmed a clip, the stabilization turned off and it won't turn on again.
-
Feb 16, 2016 4:59 PM in response to diar5714by Tom Wolsky,TThat makes it more probable on a short section that won't stabilize, while average out a longer section will.
I Tried it on a bunch on clips in the current version and can't repeat the problem.
-
Feb 16, 2016 5:04 PM in response to Tom Wolskyby diar5714,The section is 30 seconds long. I have stabilized clips shorter than that with no problem.
-
Feb 16, 2016 5:24 PM in response to diar5714by Tom Wolsky,TThe length doesn't matter. It's the content that matters. Maybe you could export this shot and post it somewhere that it can be downloaded.
-
Feb 16, 2016 5:38 PM in response to Tom Wolskyby diar5714,Never mind, I had to download the latest version. It works perfectly now! Thanks for your help though!
