Reverse position in Midi Transform not Working

just make sure the start and end positions are setup correctly. Then just hit select and operate.

Do this in the piano roll so you can see the note selection occur and make sure it is working ok.

It works fine here.

Hi

Cyril Blanc wrote:

I did set the start and stop position to 71 1 1 1 and 77 1 1 1

The Transform "Inside" functionality is relative to the start of the Region, NOT the absolute bar numbers in the project

In this "Select only' example, the selected region starts at bar 7, but to select notes within it to reverse, you have to set the transform position parameters correctly:

Select inside bars 1.1.1.1 and 5.1.1.1 within that region.

A second example:

Select inside bars 3.1.1.1 and 5.1.1.1 within that region.

One solution would be to join all your regions together, making sure that the resulting region starts at bar 1. Then you could 'select inside' using the transform as absolute bar numbers

CCT

IF no events are selected you can press select/operate to do both steps at once.

OR you can press select to see what the transformer is selecting then press operate to execute the function.

IF no events are being selected when you press select - then check the parameters of the transformer and make sure you have regions or staffs highlighted that would be applicable to where you want focus of the selection to be

you are pressing operate and not trying to press reverse right?

After you press select not you have to press operate to execute the reverse

save your project as a package file.

upload it using www.wetransfer.com and send it to yourself (via email).

then when you receive the link, copy and paste it here so we can take a look at it.