jpat1169
Level 1 (5 points)
iLife

Q: Selecting content from a clip in iMovie 10.1.2

I am using iMovie 10.1.2. I imported a 20-minute long video of a volleyball match. iMovie considers the whole movie a "clip". I need to pull smaller clips (content) from the longer movie for a highlight film. "Help" section says I can hold down the R key and drag to select content within the clip (20-minute movie), but this is not working. Please help!!

 

I used an older version of iMovie previously, and it allowed me to select content just by holding down the mouse button and dragging.

iMovie 10, OS X El Capitan (10.11.6)

Posted on Sep 19, 2016 3:14 PM

by Jim Wanamaker,Apple recommended
Jim Wanamaker Jim Wanamaker
Level 4 (3,919 points)
iLife
A:

The R key usage came with iMovie 10.1.2. In the browser place your cursor over where you want the selection to begin. Then hold down the R key and drag to complete the selection. You can also place the cursor over the start point of your desired selection and hit the i key. Then drag to where you want the selection to end and press the o key.

Posted on Sep 19, 2016 4:19 PM

Close
jpat1169

Q: Selecting content from a clip in iMovie 10.1.2

  • All replies
  • Helpful answers

  • by Jim Wanamaker,Apple recommended

    Jim Wanamaker Jim Wanamaker Sep 19, 2016 4:19 PM in response to jpat1169
    Level 4 (3,919 points)
    iLife
    Sep 19, 2016 4:19 PM in response to jpat1169

    The R key usage came with iMovie 10.1.2. In the browser place your cursor over where you want the selection to begin. Then hold down the R key and drag to complete the selection. You can also place the cursor over the start point of your desired selection and hit the i key. Then drag to where you want the selection to end and press the o key.

  • by StormyMac,

    StormyMac StormyMac Sep 21, 2016 2:00 PM in response to jpat1169
    Level 1 (4 points)
    iLife
    Sep 21, 2016 2:00 PM in response to jpat1169

    I'm having the same issue. I can use the shorter clip, but when I go to export it, iMovie counts the whole thing.

  • by GeeD,

    GeeD GeeD Sep 21, 2016 3:44 PM in response to StormyMac
    Level 5 (7,730 points)
    Video
    Sep 21, 2016 3:44 PM in response to StormyMac

    After you have selected part of a clip in an event you have to put it in a project timeline and export from there.  Exporting directly from an event pane will always export the whole clip.

     

    Geoff.

  • by StormyMac,

    StormyMac StormyMac Sep 21, 2016 5:07 PM in response to GeeD
    Level 1 (4 points)
    iLife
    Sep 21, 2016 5:07 PM in response to GeeD

    I think I've got it now. I went to the event, shortened the clip down and exported it. Then, I reimported the shortened clip and used that one.

     

    Thanks!